phasing in drum beats

JungleFever

Member
VIP Junglist
Messages
847
Likes
16
#1
Hi, I use fruity loops and recenty I been tryin to figure out how you would phase in my beat?

I mean by starting at zero volume and slowly phasing into the normal beat..

if anyone can help me out id appreciate it

cheers fellas!:confused:
 

RUSSLA

Technique
VIP Junglist
Messages
6,493
Likes
1,091
#2
You mean Fading, not phrasing.

And i'm not of FL but I guess you just need to automate the volume slider at the points you want it go up.
 
Messages
173
Likes
0
#3
^^this

easy way to do it is to bounce however many bars you want to fade in over to a wav file, then load that up as a sample, right click the volume knob and then 'create automation clip' you can click in the bit of the screen above the split it will chuck you a volume envelope. you can then adjust your volume to fade in as you wish. (you can also do it by routing the wav to a mixer channel and automating that volume control in the same way)

there's more than likely a much easier way to do this but i normally seem to find the long way round!
 

Mr Fletch

aka KRONIX
VIP Junglist
Messages
3,974
Likes
237
#5
^^this

easy way to do it is to bounce however many bars you want to fade in over to a wav file, then load that up as a sample, right click the volume knob and then 'create automation clip' you can click in the bit of the screen above the split it will chuck you a volume envelope. you can then adjust your volume to fade in as you wish. (you can also do it by routing the wav to a mixer channel and automating that volume control in the same way)


there's more than likely a much easier way to do this but i normally seem to find the long way round!
Why would you need to bounce it out to a wav first? You can automate the volume or any other dial straight off the bat.
 

miszt

BASSFACE Royale
VIP Junglist
Messages
2,944
Likes
360
#6
Why would you need to bounce it out to a wav first? You can automate the volume or any other dial straight off the bat.
definitly the easiest way to do it

personally I prefer not to touch the channel faders except for the final stage of mixdown, just makes life simpler knowing I dont have to worry about screwing up automation later on
 
Top